Difference between revisions of "Git"
Jump to navigation
Jump to search
| Line 10: | Line 10: | ||
upgrade_by_git = yes | upgrade_by_git = yes | ||
git_folder = /usr/src/voipmonitor-git | git_folder = /usr/src/voipmonitor-git | ||
| − | The sniffer will perform (after click on UPGRADE in GUI) git pull,make, service voipmonitor stop, make install, service voipmonitor start | + | The sniffer will perform (after click on UPGRADE in GUI) git pull,configure,make_clean,make, service voipmonitor stop, make install, service voipmonitor start |
Latest revision as of 18:41, 22 June 2018
GIT upload
If you attempt to push a large set of changes to a Git repository with HTTP or HTTPS, you may get an error message such as error: RPC failed; result=22, HTTP code = 411. This is caused by a Git configuration default which limits certain HTTP operations to 1 megabyte. To change this limit run within your local repository
git config http.postBuffer *bytes*where bytes is the maximum number of bytes permitted. For exmaple:
git config http.postBuffer 524288000
self compiled sniffer from GIT sources
If customer use self compiled sniffer from git, (napatech card card not supported in static binaries provided by voipmonitor.org) set in sniffer's /etc/voipmnitor.conf
upgrade_by_git = yes git_folder = /usr/src/voipmonitor-git
The sniffer will perform (after click on UPGRADE in GUI) git pull,configure,make_clean,make, service voipmonitor stop, make install, service voipmonitor start