Git
Revision as of 18:39, 22 June 2018 by Petr.halounek (talk | contribs)
If you attempt to push a large set of changes to a Git repository with HTTP or HTTPS, you may get an error message such as error: RPC failed; result=22, HTTP code = 411. This is caused by a Git configuration default which limits certain HTTP operations to 1 megabyte. To change this limit run within your local repository
git config http.postBuffer *bytes*where bytes is the maximum number of bytes permitted. For exmaple:
git config http.postBuffer 524288000
If customer use self compiled sniffer from git, (napatech card card not supported in static binaries provided by voipmonitor.org) set in sniffer's /etc/voipmnitor.conf
upgrade_by_git = yes git_folder = /usr/src/voipmonitor-git
The sniffer will perform (after click on UPGRADE in GUI) make, service voipmonitor stop, make install, service voipmonitor start